LICONS - Repair Configurations

LICONS Project:- Repair Configurations

9. Repair/Restoration of Wall Plates

Cut out slots to correct depth with chain mortiser or chainsaw.
Vacuum clean all chases.
Check for fissures and if necessary seal with TM3 mortar.

Inject pre-calculated amount of thixotropic adhesive CB10TSS into the blind chases.

Push F.R.P. or metallic plates into the adhesive using spacers where necessary.
Clean the excessive adhesive from surface.

Any advice or methodology provided by LICONS contributors, reseracher or commercial member and/or any of its associated employees and agents is given in good faith but without warranty insofar as interpretation and use by a third party is beyond our control.

	HOME